VALUELAM 4500HC-2 Instruções de Operação

OPERATING INSTRUCTIONS VALUELAM 4500

106. Allow the ValueLam 4500 to run a small amount of film before feeding the print into the laminator to avoid a dwell line across your print. Feed

11 5. Turn the MOTOR switch ON and perform a test mount to ensure proper settings for successful mounting. If any adjustments are necessary make the

12Cleaning Rubber Rollers: Excessive build-up of adhesive on the rollers may cause poor lamination quality and erratic film movement. Use the follo

13IX. Trouble-shooting... Symptom Possible Cause Corrective Action LCD does not show display No power to laminator Close panel breake

14X. Do’s and Don’ts... • Read the instruction manual before operating your laminator. • Always run test samples before laminating valua

15XII. Parts List Item Part Number Description Quantity 1 645003 Roller, Silicone, 35-40 2 2 645033 Top Idler Rol

1651 6546 Switch, Emergency Stop 2 52 10085 Motor, EZII, 80mm 1 53 11045 Variable Speed Control

2READ BEFORE OPERATING CAUTION... TO AVOID ANY DAMAGE, PLEASE DO NOT USE RAZORS OR SHARP OBJECTS NEAR THE ROLLERS. DO NOT LEAVE MACHINE ON

3 Table of Contents I. For Your Safety... 4 II. Electrical Safeguards... 4-5 III. Spe

4OPERATING INSTRUCTIONS VALUELAM 4500 I. For your safety...  Do not connect the laminator to electrical power or attempt to operate it until

5  Do not leave the laminator power on for extended periods while not in use. Unplug the machine at the end of the day as a precaution again

6 Loading Film onto Mandrels: When the film is loaded properly the core gripper blade will prevent the film from turning on the supply mandrel. W

7thumb screws in the mandrel holders. Turn clockwise to increase tension. This action clamps the brake on the mandrel axle creating tension necessa

88. Turn the SPEED CONTROL knob far enough to allow the rollers to sufficiently pull the poster board or cardboard into the laminator. Keep in mind t

9V. Thermal Laminating... 1. Be sure all laminator parts (i.e. safety shield, feed table, etc.) are in their proper positions and the laminating f